We have designed and supply an alternative leg assembly for the Gregoire Besson Discordon  cultivator

Our objective at the outset was to  improve drainage and use less  Horsepower / Diesel  1" - 12" Deep

The leg assembly consists of 2 parts, 1 part above soil, 1 part below , attached with 1 roll pin

Top section is 30mm thick to mimic original leg bolt hole pattern

Soil engaging section is a slim 15mm thick for low surface disturbance and low draft

Point is 30mm wide, and std wings are 75mm wide, set on @ 5 degree lift angle ( approx 1/2 of the norm )

The result is a level  full width lift , tested at up to 10mph  ( 6-7 mph recommended )

All  parts made from Hardox 500  material, Carbide Points optional, weld on parts available

          Upper Leg Assy £110.00                    Carbide shank assy  £44.90  std  £38.90